Flywheel, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Nut

Courtesy of AUDI OF AMERICA, LLC

Secure the transmission on the Engine And Transmission Holder VAS6095, refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .

-- Remove the left flange shaft, refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Attach the Puller - Clutch Module T40176 to the flywheel -A- with the nut -B- -arrow-.

-- Turn the Puller - Clutch Module T40176 upward.

Fig 2: Identifying Flywheel Components, Remove/Install

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To prevent the flywheel from tilting, counter hold it underneath as illustrated.

-- Remove the flywheel from the input shaft -arrow-. Do not tilt the flywheel when doing this.