Securing On Engine And Transmission Holder
WARNING: This page is about a different car, the 2015 Audi S7, 2014 Audi S7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Engine And Transmission Holder VW 6095
- Holding Plate VW 309A
- Hook And Support Tool T40197
- Hook and Support Tool T40294
CAUTION:
Do not use the Hook And Support Tool T40197 for the repair (Refer to Sensor Module --, WITH INTEGRATED TRANSMITTERS AND SENSORS -G612-, -G632-, -G676 - AND Circuit Board 3 --, REMOVING AND INSTALLING ) - There is a risk of injury.
Only use the Hook and Support Tool T40294 for this operation.
Procedure
- Hold the transmission with the Shop Crane VAS 6100, refer to TRANSMISSION, TRANSPORTING .
-- Attach the Holding Plate VW 309A to the Hook And Support Tool T40197.
-- Place the transmission using the Shop Crane VAS 6100 in the Engine And Transmission Holder VAS 6095.
NOTE:
The vents for the transmission housing and final drive must be closed before turning a filled transmission with oil pan upward on the engine and transmission holder.