Receiver/Dryer, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Installation is done is reverse order, observe the following:
-- Replace the O-ring seals depending on the version.
-- Clean the condenser surface -C-.
-- Check the connections on the condenser and on the receiver/dryer for damage.
-- Insert the O-ring seals -D and E- into the grooves -arrows- on the respective connection.
NOTE:
Coat the O-ring seals lightly with refrigerant oil prior to installation, refer to REFRIGERANT CIRCUIT SEALS .
Inspect the refrigerant pipes leading to the evaporator for debris and damage.
Check O-ring seals for proper seating in groove -arrow- on the respective connection.
-- Mount the receiver/dryer -B- on the condenser and tighten the bolts.