Refrigerant Circuit Seals
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Always use O-rings only once, replace.
- Coat the O-ring seals with refrigerant oil before inserting.
- Make sure O-rings are seated properly on pipe or in groove.
- Perform the work under clean conditions (even the smallest deposit such as a hair may cause a leak).
NOTE:
Install only O-rings that are resistant to refrigerant R134a and corresponding refrigerant oil. The O-ring seals are color-coded to avoid mistakes (currently "red", "light purple" or "dark purple") .
The dimensions -a and b- are different depending on the component location of the O-ring seal .
In addition to the color-coded O-ring seals, use is also made at the factory of black O-ring seals for certain connections.