Impact Member, Removing And Installing, Audi RS7: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Impact Member, Audi RS6

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear bumper cover. Refer to REMOVING .

-- Remove the bolts -arrows-.

-- Tie up the bracket -1- with the central valve to the side.

-- Remove the spare tire well trim. Refer to SPARE WHEEL WELL TRIM, REMOVING AND INSTALLING .

Fig 2: Identifying Nut And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -2- and bolts -1, 4 and 5-.

-- Remove the impact member -3-.