LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Body Exterior - Bumpers) >> 63 Bumpers >> Rear Bumper >> Cable Mount, Removing And Installing >> Removing

Cable Mount, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Pull the pull knob -6- on the mount -3- and pry off the clamp -5- with a narrow screwdriver -arrow-.

-- Remove the cable -4- from the pull knob.

-- Remove the bolts -1, 2 and 7-.

-- Remove the cable bracket -1- from the mount -3- -arrow-.

Fig 1: Removing Cable Bracket From Mount
GWWA63-10490Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- and remove the mount.