Bumper Cover, Removing And Installing, Vehicles Through MY 2014: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Gap dimensions. Refer to BUMPER COVER GAP DIMENSION .
Tightening specifications. Refer to OVERVIEW - BUMPER COVER .

Install in reverse order of removal. Note the following:

-- Connect electrical harness connectors.

-- Install the cable mount. Refer to Installing .

-- Install the outer tail lamps. Refer to OUTER TAIL LAMPS .

-- If the vehicle has lane change assistance, the lane change assistance control module -J769- / -J770- must be recalibrated. Refer to LANE CHANGE ASSISTANCE CONTROL MODULES -J769- / -J770-, CALIBRATING .