Right Impact Member Mount, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification. Refer to OVERVIEW - IMPACT MEMBER .

Install in reverse order of removal. Note the following:

-- Tighten the impact member mount according to the marking made during removal.

-- Connect the secondary air injection pump.

-- Install the connecting brace. Refer to Installing .

-- Install the impact member. Refer to Installing .

-- Install the right wheel spoiler. Refer to FRONT WHEEL SPOILER, REMOVING AND INSTALLING, AUDI A7/S7 .

-- Install the front noise insulation. Refer to FRONT NOISE INSULATION, REMOVING AND INSTALLING .