Front Bumper Cover Mount, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pressing Front Bumper Cover Mount Against Headlamp Housing

Courtesy of AUDI OF AMERICA, LLC

Gap dimensions. Refer to BUMPER COVER GAP DIMENSION .
Tightening specifications. Refer to OVERVIEW - BUMPER COVER .

Install in reverse order of removal. Note the following:

-- Press the front bumper cover mount -3- against the headlamp housing -2- -arrow-, hold it in this position and then tighten the bolt -1-.

The rib -4- on the mount must touch the headlamp housing.

-- Install the front bumper cover. Refer to Installing .