Cylinder Bank 1 (Right) Ignition Coils, Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING (CEUC And CRDB) .

-- Disconnect the connectors and free up the wires:

Fig 1: Identifying Connectors

Courtesy of AUDI OF AMERICA, LLC

1 - for ignition coils -N70-, -N127-, -N291-, and -N292-

2 - for Camshaft Position Sensor -G40-

4 - for intake or exhaust camshaft adjuster -F456-, -F457-, -F458-, and -F459-

5 - for Intake Air Temperature Sensor -G42-

6 - for intake or exhaust camshaft adjuster -F452-, -F453-, -F454-, and -F455-

-- Disconnect vacuum hoses -3 and 7-.

-- Remove the screws -arrows-.

-- Free up the ground wire and tilt the wiring guide back.

-- Remove the ignition coils. Refer to Cylinder Bank 2 (Left) Ignition Coils, Removing .