LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Maintenance Procedures) >> 03 Maintenance, Diagnosis >> Maintenance Procedures >> Plenum Chamber, Water Drain, Checking And Cleaning (If Necessary) >> Plenum Chamber, Checking For Debris >> Checking the Water Drain on the Driver Side

Checking the Water Drain on the Driver Side

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the windshield washer fluid reservoir filler tube bolts -arrows-.

Fig 1: Identifying Bolts
GWWA92-10232Courtesy of AUDI OF AMERICA, LLC

-- Lift the filler tube -1- carefully. Do not completely remove.

-- Check the water drain grommets -1- and water drains -arrows- for debris.

Fig 2: Identifying Water Drains And Grommets
GWWA87-10907Courtesy of AUDI OF AMERICA, LLC

-- Check the plenum chamber for debris.

-- If necessary clean the plenum chamber and water drain. Refer to CLEANING THE PLENUM CHAMBER AND WATER DRAIN GROMMETS .

-- Position the windshield washer fluid reservoir filler tube and tighten the bolts to the tightening specification.

Tightening specification Nm
Filler tube bolts 8
- -
scientia non olet · About LEMON Manuals