Coolant Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Drive Axle

Courtesy of AUDI OF AMERICA, LLC

NOTE: Replace the seal and O-rings.

-- Install the O-ring -1-.

-- Insert the coolant pump input shaft -2- into the oil pump mount as far as the stop.

-- Push the coolant pump -1- into the brackets on the upper part of the oil pan.

Fig 2: Identifying Coolant Pump

Courtesy of AUDI OF AMERICA, LLC

NOTE: To connect the drive flange onto hex head of drive axle, turn at the impeller -2- until the coolant pump can be inserted completely.

Installation is performed in reverse order of removal, while noting the following:

-- Install the engine oil cooler, refer to ENGINE OIL COOLER, REMOVING AND INSTALLING, FRONT .

-- Install the front lower coolant pipe, refer to Installing .

-- Install the radiator, with the fan shroud, refer to Installing .

-- Install the Map Controlled Engine Cooling Thermostat -F265-, refer to Installing .

-- Connect the coolant hose to the coupling, refer to Figure.