Bumper Cover Mount, Removing And Installing, Vehicles From My 2015: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Remove the headlamp housing. Refer to REMOVAL AND INSTALLATION .

-- Remove the right air filter housing. Refer to [For engine(s) CPNB] Air Filter or [For engine(s) CEUC,CRDB] Air Filter [For engine(s) CTUA,CGXB] Air Filter .

-- Left side of Audi S7/RS 7: Remove the secondary air injection pump motor with bracket. Refer to [For engine(s) CEUC,CRDB] Secondary Air Injection System [For engine(s) CTUA,CGXB] Secondary Air Injection System .

-- Disconnect and free up the connector -1-.

Fig 1: Disconnecting And Free Up Connector -1-

Courtesy of AUDI OF AMERICA, LLC

-- If equipped disconnect the connector for the NOx Sensor Control Module -J583-.

-- Remove the bolts -1, 3 and 4-.

Fig 2: Removing Bolts -1, 3 And 4-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bracket -2-.