LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Heating, Ventilation & Air Conditioning (Actuators - Front Heater And A/C Unit)) >> 87 Air Conditioning >> Front Heater And A/C Unit >> Fresh Air Blower -V2-, Removing And Installing >> Fresh Air Blower -V2- With Fresh Air Blower Control Module -J126-, Notes

Fresh Air Blower -V2- With Fresh Air Blower Control Module -J126-, Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Currently an Auxiliary Heater Heating Element -Z35- is also installed on vehicles with a high voltage system (hybrid vehicles) and a gasoline engine, refer to ELECTRICAL AUXILIARY HEATER ACTIVATION, CHECKING .

For vehicles with a gasoline engine, the electric auxiliary heater (the Auxiliary Heater Heating Element -Z35-) is activated by the Climatronic Control Module -J255- control head via the local data bus (activated via the same outlet and also via the Fresh Air Blower Control Module -J126-) on the Auxiliary Air Heater Control Module -J604-. If there is a complaint with these vehicles, check the Fresh Air Blower Control Module -J126- or Fresh Air Blower -V2- and the Auxiliary Air Heater Control Module -J604-. Use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function and appropriate System Wiring Diagram.

Make sure to use the correct version of the Fresh Air Blower Control Module -J126-. For vehicles with a high voltage system (hybrid vehicles) and gasoline engines, additional information is sent to activate the Auxiliary Air Heater Control Module -J604-, for example via the local Data bus.