LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Heating, Ventilation & Air Conditioning (A/C Compressor & Actuators)) >> 87 Air Conditioning >> A/C Compressor >> Drive Plate With Overload Protection, Removing And Installing >> Tightening Specifications

Tightening Specifications

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Position the drive plate with the overload protection -B- onto drive plate.

-- Insert the bolts and tighten them all the way by hand.

-- Check the drive plate run-out, refer to DRIVE PLATE WITH OVERLOAD PROTECTION, CHECKING RUN-OUT AND ADJUSTING .

-- Tighten the bolts.

-- Check the drive plate run-out again.

scientia non olet · About LEMON Manuals