Overview - Center Differential Housing, Attached Driveshaft: Notes
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to REPAIR INFORMATION .
Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Bolt
- 20 Nm +90°
- Replacing
- Bolt
- Replacing
- Aluminum bolts
- Quantity 11
- Tightening specification and sequence. Refer to Tightening Specifications .
- Housing
- For the center differential
- Refer to CENTER DIFFERENTIAL HOUSING, REMOVING AND INSTALLING
- Gear Carrier
- Installed position: The tab must fit into the opening in the transmission intermediate housing
- Center Differential
- Pressure Spring
- Assembly Sleeve
- Does not have to be installed again
- Locking Ring
- For the transmission output shaft ball bearing with splines
- Removing and installing. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Locking Ring
- For the transmission output shaft with splines
- Removing and installing. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Ball Bearing
- For the transmission output shaft with splines
- Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING
- Bolt
- Replacing
- Steel bolts
- Quantity: 2
- Tightening specification and sequence. Refer to Tightening Specifications .
- Balance Weight
- Installed depending on the version
- Shaft Seal
- Replace on vehicles with vibration damper. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Replace on vehicles without vibration damper. Refer to TRANSMISSION OUTPUT SHAFT SEAL, REPLACING, TRANSMISSION OUTPUT SHAFT WITH SPLINES WITHOUT VIBRATION DAMPER
- Dust Ring
- Replace after removing
- Transmission Output Shaft with Splines without Vibration Damper
- For allocation refer to the Parts information.
- Removing and installing. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Transmission Output Shaft with Splines and Vibration Damper
- For allocation refer to the Parts information.
- Removing and installing. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .