Turbocharger Control Module 1 -J724-, REMOVING AND INSTALLING, VEHICLES WITH TWO TURBOCHARGER MANUAL MODES: Notes

Special Tools And Workshop Equipment Required 

• Turbo E-Positioner Service Kit :VAS6395  / :VAS6395A  or :VAS6395B 
• Turbo E-Positioner Service Kit - Bracket :VAS6395 /7 

Correct the Turbo E-Positioner Service Kit - Bracket :VAS6395 /7  if necessary.

Courtesy of AUDI OF AMERICA, LLC

Reworking of the opening -arrow- shown in the image half -A- is not required.

-- If the opening does not exist, rework the bracket Turbo E-Positioner Service Kit - Bracket :VAS6395 /7  using a file as shown in image half -B-.

Removing

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the plenum chamber bulkhead. Refer to BULKHEAD . .

-- Release the cover -3- and pivot it to the side -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Connect the Turbo E-Positioner Service Kit :VAS6395  to the positive terminal -2- and to the ground -1- using the Turbo E-Positioner Service Kit - Wire Set :VAS6395/2  .

NOTE:

The following procedure description uses the Turbo E-Positioner Service Kit - E Box :VAS6395 /1  or :VAS6395A/1 

Depending on the equipment stock in the workshop, the E-Box :VAS6395 B/1  can also be used.

The button positions are arranged differently, but the labels and functions are the same. (See image below).

Courtesy of AUDI OF AMERICA, LLC

Procedure for E-Box :VAS6395 B/1  and E-Box : VAS6395A/1  :

Courtesy of AUDI OF AMERICA, LLC

-- Select the software version SW Hella  using the ↑  -item 5- and ↓  -item 6- buttons.

-- Press the v  button -item 4- to confirm the software version.

Procedure for the Turbo E-Positioner Service Kit - E-Box :VAS6395A/1  :

Courtesy of AUDI OF AMERICA, LLC

Software Version of the Tester for E-Positioner - E-Box :VAS6395B/1  , Checking:

If the correct software is loaded, the following will be displayed on the Tester for E-Positioner - E-Box :VAS6395B/1  (two seconds after the voltage supply is connected):

1. >1. START
2. 2. NEXT [>]

or

>1. START Bi-Turbo

2. NEXT [>]

If the following appears in the display, then incorrect software has been loaded:

1. >1. TEST
2. 2. LEARN