Clean Working Conditions

Even a little contamination can lead to faults. Observe the following guidelines for cleanliness when working on the fuel system, injection system and turbocharging system:

• Before loosening, connections and surrounding areas must be cleaned thoroughly with engine or brake cleaner, and then cleaned area must be dried completely.
• Seal off any open lines and connections immediately with plugs, for example, take from Engine Bung Set :VAS6122  .
• Place the removed parts on a clean surface and cover them. Only use lint-free cloths!
• Carefully cover or seal opened components if repairs are not performed immediately.
• Install only clean parts: remove the replacement parts from their packaging just before installing them. Do not use parts that have been stored out of their original packaging (for example, in tool boxes etc.).
• When the system is open: do not work with compressed air. Do not move vehicle unless absolutely necessary.
• Protect the disconnected connectors from dirt and moisture and only connect when they are dry.
• In addition, do not let diesel fuel flow onto coolant hoses. If necessary, the hoses must be cleaned again immediately. Replace corroded hoses.