Pistons, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Engine is secured to the :VAS6095 . Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .

-- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Remove the oil pump. Refer to OIL PUMP, REMOVING AND INSTALLING

-- Remove the bolts -1 through 6- and remove the baffle plate.

Courtesy of AUDI OF AMERICA, LLC

-- Mark the installed position and to which connecting rod bearing cap and cylinder and the connecting rod it belongs for installing again later. Refer to figure in Piston Installation Position .

-- Remove the connecting rod bearing cap.

-- Remove the piston and connecting rod upward.

-- Remove the circlip -2- from the piston pin eye.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the piston pin -3- using the Pilot Drift :VW 222A .

NOTE:

Warm the piston to approximately 60 °C (140 °F) if it is difficult to move the piston pin.

-- Remove the pistons -1- from the connecting rod -4-.