Engine, Securing On Engine And Transmission Holder
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Engine and Transmission Holder :VAS6095A with Engine/Transmission Holder - V8 Engine Bracket :VAS6095/1-13
-- Free up the wiring harness.
-- Remove the nut -3- and free up the hose clamp.
-- Loosen the clamps -arrows- to remove the coolant hose from the upper left coolant pipe -2-.
-- Unclip the upper left coolant pipe from the mount -1-.
-- Remove the bolts -arrows- and remove the left engine support.
-- Free up the wiring harness.
-- Remove the nut -2- and free up the ground wire.
-- Remove the bolts -arrows- and remove the right engine support -1-.
-- Secure the starter on the engine.
-- Attach the engine using the :VAS6095/1-13 to the :VAS6095A and tighten to 55 Nm, as shown in the illustration.