Overview - Cylinder Block, Transmission Side

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For assembly work, secure the engine on the Engine and Transmission Holder :VAS6095A . Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .

Fig 1: Exploded View Of Cylinder Block, Transmission Side

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 60 Nm + 90° turn
- Always replace
Drive Plate
- With the bearing flange
- Check the running surfaces on the bearing flange and the dual mass flywheel holes for cracks and signs of wear.
- Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
Sensor Wheel
- For Engine Speed Sensor -G28-
- Removing and installing. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .
- Checking. Refer to SENSOR WHEEL, CHECKING .
Shaft Seal
- Always replace. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
- For the crankshaft on the transmission side
Crankshaft
Alignment Pin
- If a new engine or a new crankshaft is installed, install a new alignment pin. Allocation.