Engine Mount
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Engine Mount Exploded View
- Bolt
- 6 Nm
- Subframe Mount Sensors
- Right side: Subframe Mount Sensor 1 -G748-
- Left side: Subframe Mount Sensor 2 -G749-
- Removing and installing. Refer to SUBFRAME MOUNT SENSOR, REMOVING AND INSTALLING .
-- Calibrate the electro-hydraulic engine mount after calibrating. Refer to ELECTRO-HYDRAULIC ENGINE MOUNT, CALIBRATING .
- Engine Mount and Actuator for Subframe Mount
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
-- Calibrate the electro-hydraulic engine mount after calibrating. Refer to ELECTRO-HYDRAULIC ENGINE MOUNT, CALIBRATING .
- Includes Subframe Mount Actuator 1 -N513- on the right side
- Includes Subframe Mount Actuator 2 -N514- on the left side
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Engine Mount Bracket
- Bolt
- 40 Nm
- Engine Support
- Bolt
- 90 Nm + 90°
- Always replace
- Subframe
- Bolt
- 55 Nm
Subframe Mount Control Module -J931-
- Bracket
- Connector
- Subframe Mount Control Module -J931-
- Removing and installing. Refer to Subframe Mount Control Module -J391-, REMOVING AND INSTALLING .
-- Calibrate the electro-hydraulic engine mount after calibrating. Refer to ELECTRO-HYDRAULIC ENGINE MOUNT, CALIBRATING .
- Removing and installing. Refer to Subframe Mount Control Module -J391-, REMOVING AND INSTALLING .