Electro-Hydraulic Engine Mount, Calibrating
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
A calibration must be performed only on electro-hydraulic engine mounts with Subframe Mount Sensor 1 -G748- and Subframe Mount Sensor 2 -G749- as well as Subframe Mount Actuator 1 -N513- and Subframe Mount Actuator 2 -N514-.
Special Tools And Workshop Equipment Required
- Vehicle Diagnostic Tester
Procedure
-- Connect the Vehicle Diagnostic Tester.
-- Select the Diagnostic mode and start the diagnosis.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Drivetrain
- Engine - auxiliary and subsystem
- 01 - OBD-capable systems
- BA- Subframe Mount Control Module
- BA - Subframe Mount Control Module, Functions
- BA - Performing Basic Setting
- Preform the test