Overview - Bumper Cover, RS4 And RS5

Fig 1: Exploded View Of Rear Bumper Cover, RS4 And RS5

Courtesy of AUDI OF AMERICA, LLC

Trim
- For the bumper cover
- Removing and Installing. Refer to BUMPER COVER TRIM, REMOVING AND INSTALLING, RS4 AND RS5 .
Bumper Cover Lower Section
- Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING, RS4 AND RS5 .
Rear Reflector
- With spring
- Removing and Installing. Refer to REFLECTOR, REMOVING AND INSTALLING .
Small Reflector
- Removing and Installing. Refer to REFLECTOR, REMOVING AND INSTALLING, NOT RS4 AND RS5 .
Bolt
- 2 Nm
Bolt
- 2 Nm
Bolt
- Quantity: 3
- Tightening specification OVERVIEW - BUMPER COVER MOUNT
Mount
- For the bumper cover
- Side
- Overview. Refer to OVERVIEW - BUMPER COVER MOUNT .
Bolt
- Quantity: 3
- Tightening specification. Refer to OVERVIEW - LANE CHANGE ASSISTANCE .
Mount
- For securing the bumper cover
- Overview. Refer to OVERVIEW - BUMPER COVER MOUNT .
Locking Mechanism
- For attaching the rear bumper cover to the upper mount
Bolt
- Quantity: 2
- Tightening specification OVERVIEW - BUMPER COVER MOUNT
Mount
- For lane change assistance control module
- Overview. Refer to OVERVIEW - LANE CHANGE ASSISTANCE .
Nut
- 4 Nm
- Quantity: 4
Bumper Cover
- Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
Cover
- For the towing eye
Clip
- Quantity: 4
Center Trim Molding
- Removing and Installing. Refer to BUMPER COVER TRIM MOLDING, REMOVING AND INSTALLING, RS4 AND RS5 .
Side Trim Molding
- Removing and Installing. Refer to BUMPER COVER TRIM MOLDING, REMOVING AND INSTALLING, RS4 AND RS5 .
Nut
- 2 Nm
- Quantity: 2