Overview - Bumper Cover, A4 ALLROAD

Fig 1: Exploded View Of Rear Bumper Cover, A4 Allroad

Courtesy of AUDI OF AMERICA, LLC

Bumper Cover Lower Section
- Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .
Rear Reflector
- Removing and Installing. Refer to REFLECTOR, REMOVING AND INSTALLING, A4 ALLROAD .
- Screw tightening specification: 2 Nm
Spring
- For rear reflector
Bumper Cover Lower Section
- Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .
Bolt
- 2 Nm
Bolt
- Quantity: 3
- Tightening specification OVERVIEW - REAR WHEEL HOUSING LINER
Expanding Nut
Bumper Cover Upper Section
- Removing and Installing. Refer to BUMPER COVER UPPER SECTION, REMOVING AND INSTALLING .
- Overview - Bumper Cover Mount. Refer to OVERVIEW - BUMPER COVER MOUNT
Securing Strip
Bolt
- Quantity: 3
- Tightening specification. Refer to OVERVIEW - LANE CHANGE ASSISTANCE .
Mount
- For lane change assistance control module
- Overview. Refer to OVERVIEW - LANE CHANGE ASSISTANCE .
Nut
- 4 Nm
- Quantity: 4
Sealing Washer
End Panel
- Removing and Installing. Refer to END PANEL, REMOVING AND INSTALLING .
Securing Plate
Cover
- For the towing eye
Nut
- 2 Nm
- Quantity: 2