Overview - Heater & A/C Unit, Heater Core, "DENSO" Auxiliary Heater Heating Element
WARNING: This page is about a different variant/trim than selected.
- Heat Exchanger
- There are different versions.
- Removing and installing. Refer to HEATER CORE, REMOVING AND INSTALLING .
- Bracket
- Bolt
- 2 Nm
- O-Ring Seal
- Always replace. Refer to HEATER CORE, REMOVING AND INSTALLING .
- There are different versions.
- Screw Clamp
- Bolt tightening specification 2 Nm
- Coolant Pipe for the Heater Core
- There are different versions.
- Coolant supply from engine
- Removing and installing. Refer to HEATER CORE, REMOVING AND INSTALLING .
- Screw Clamp
- Bolt tightening specification 2 Nm
- O-Ring Seal
- Always replace. Refer to HEATER CORE, REMOVING AND INSTALLING .
- There are different versions.
- Coolant Pipe for the Heater Core
- There are different versions.
- Coolant return to engine
- Removing and installing. Refer to HEATER CORE, REMOVING AND INSTALLING .
- Bolt
- 2 Nm
- Foam Spacer
- For sealing/insulating
- Observe installed position
- Bracket
- For the coolant pipes
- Foam Piece
- For insulating
- Observe installed position
- Heater and A/C Unit
- On vehicles without an Auxiliary Heater Heating Element -Z35-, the opening for the auxiliary heater is sealed.
- Removing and installing. Refer to HEATER AND A/C UNIT, REMOVING AND INSTALLING .
- Disassembling and assembling. Refer to HEATER AND A/C UNIT, DISASSEMBLING AND ASSEMBLING .
- Auxiliary Heater Heating Element -Z35-
- Activation, checking. Refer to AUXILIARY HEATER ACTIVATION, CHECKING (THE AUXILIARY HEATER HEATING ELEMENT -Z35-) .
- Removing and installing. Refer to AUXILIARY HEATER HEATING ELEMENT -Z35-, REMOVING AND INSTALLING .
- Bolt
- 2 Nm
- Quantity: 2
- Wire
- For Auxiliary Heater Heating Element -Z35-
- Removing and installing. Refer to AUXILIARY HEATER HEATING ELEMENT -Z35-, REMOVING AND INSTALLING .
- Ground Cable
- Nut -9 Nm
- For the auxiliary heater