Heater And A/C Unit, Disassembling And Assembling
WARNING: This page is about a different variant/trim than selected.
NOTE:
There are different versions and various manufacturers of the heater and A/C units. Individual components of the different heater and A/C units are similar but not the same. Interchanging components from different manufacturers is not permitted.
A heater and A/C unit manufactured by "Valeo" is shown in the following illustrations. For distinguishing characteristics between manufacturers. Refer to HEATER AND A/C UNIT IDENTIFICATION .
- Air Distribution Housing
- There are different versions. Refer to HEATER AND A/C UNIT IDENTIFICATION .
- Interchanging components is not permitted. Refer to HEATER AND A/C UNIT IDENTIFICATION .
- The following illustrations show the heater manufactured by "Valeo"
- Depending on vehicle equipment level with or without the Auxiliary Heater Heating Element -Z35-
- Manufacturer differences. Refer to HEATER AND A/C UNIT IDENTIFICATION .
- Removing and installing. Refer to AIR DISTRIBUTION HOUSING, REMOVING AND INSTALLING .
- Wiring Harness
- There are different versions.
- Evaporator Housing
- Overview. Refer to OVERVIEW - EVAPORATOR HOUSING .
- Bolt
- 1 Nm
- Quantity: 3
- Left Bracket
- For heater and A/C unit
- Removing and installing. Refer to HEATER AND A/C UNIT BRACKET, REMOVING AND INSTALLING .
- Nut
- 4.5 Nm
- Nut
- 4.5 Nm
- Right Bracket
- For heater and A/C unit
- Removing and installing. Refer to HEATER AND A/C UNIT BRACKET, REMOVING AND INSTALLING .
- Air Intake Housing
- There are different versions.
- Overview. Refer to OVERVIEW - ATTACHMENTS FOR HEATER AND A/C UNIT AND AIR INTAKE HOUSING .
- Bolt
- Tightening specification -item 4-