Heater And A/C Unit Bracket, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install In Reverse Order Of Removal. Note The Following:
- Tightening specification. Refer to HEATER AND A/C UNIT, DISASSEMBLING AND ASSEMBLING .
-- Insert the bracket -1 and 3- into the mounts on the heater and A/C unit -2- and bring the A/C unit into the installed position.
-- Install the heater and A/C unit. Refer to HEATER AND A/C UNIT, REMOVING AND INSTALLING .
-- Tighten the nut to the brackets.
-- Install the remaining components.
-- Check the DTC memory and erase any displayed entries using the :Vehicle Diagnostic Tester in the "Guided Fault Finding" function.
-- Check the heater and A/C unit function.