Air Distribution Housing, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install In Reverse Order Of Removal. Note The Following:

Tightening specification. Refer to HEATER AND A/C UNIT, DISASSEMBLING AND ASSEMBLING .

NOTE:

The smallest leaks at the tongue and groove joint between the air distribution housing and the evaporator housing can lead to whistling noises due to escaping air. Coat the connecting surfaces lightly with, for example, silicone grease. Silicone grease.

-- Install the heater and A/C unit. Refer to HEATER AND A/C UNIT, REMOVING AND INSTALLING .

-- Check the DTC memory and erase any displayed entries using the :Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

-- Check the heater and A/C unit function.