Overview - Rear Seat Backrest, Pass-Through Door
WARNING: This page is about a different variant/trim than selected.
- Center Cushion
- Removing and Installing. Refer to CENTER CUSHION, REMOVING AND INSTALLING, BACKREST WITH PASS-THROUGH .
- Engage the cushion to the pass-through door and press on it until it clicks into place.
- Center Armrest
- Removing and Installing. Refer to CENTER ARMREST, REMOVING AND INSTALLING .
- Lid
- For pass-through
- Removing and Installing. Refer to PASS-THROUGH DOOR, REMOVING AND INSTALLING .
- Trim
- for the rear lid locking mechanism
- Removing and Installing. Refer to PASS-THROUGH COVER FRAME, REMOVING AND INSTALLING .
- Press on until it engages audibly
- Stop Strip
- Clipped into the rear seat backrest
- Removing and Installing. Refer to PASS-THROUGH COVER FRAME, REMOVING AND INSTALLING .
- Press on until it engages audibly
- Cover Frame
- For pass-through
- Clipped into the rear seat backrest
- Removing and Installing. Refer to PASS-THROUGH COVER FRAME, REMOVING AND INSTALLING .
- Push in the rear seat backrest until it engages audibly.
- Right 2/3 Rear Seat Backrest
- Bolt
- Quantity: 2
- Self-locking
- Replace after removing.
- Threaded holes for the bolts must be cleaned, for example, with a thread tap
- Tightening specification. Refer to OVERVIEW - CENTER ARMREST
- Bolt
- 9 Nm
- Quantity: 2