Calibration Board Orientation

WARNING: This page is about a different variant/trim than selected.

-- Position the calibration platform behind the vehicle at a distance of 1.47 m to 1.90 m to the rear wheels, see -dimension A- in the overview illustration. Refer to INSTALLED :VAS6350A OVERVIEW .

-- Bring the :VAS6350A into a horizontal position.

-- Twist the plastic feet under the calibration board so that the air bubble in the level is located exactly in the center of the indicator -arrow-.

Fig 1: Identifying Bubble Level (Sight Glass) On Calibration Tool VAS 6350

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Make sure light does not reflect off the calibration board.

Reflections impair the Rearview Camera -R189- and may make it impossible to perform the calibration.

NOTE:

The vehicle in the illustration is only a basic outline.

Fig 2: Switching On Line Laser VAS 6350/3

Courtesy of AUDI OF AMERICA, LLC

-- Switch on the :VAS6350/3 -1- on the calibration board and adjust the entire :VAS6350A so that the laser beam hits the center of vehicle rear above the Audi rings.

-- Make sure the Audi rings are centered on the rear. Correct the laser beam accordingly.

Continue calibrating the Rearview Camera -R189-. Refer to REARVIEW CAMERA -R189-, CALIBRATING .