Installed :Vas6350A Overview
WARNING: This page is about a different variant/trim than selected.
NOTE:
The vehicle in the illustration is only a basic outline.
- :VAS6350/1
- :VAS6350/1
- Right Angle Bracket
- :VAS6350/2 mount
- Plastic Foot
- Three on underside of the calibration board
- Adjustable for aligning horizontal position of the calibration board
- Calibration Tool - Linear Laser:VAS6350/3
- On the calibration board
- Switching on and off. Refer to the Owner's Manual.
- Calibration Tool - Spacing Laser:VAS6350/2
- On the calibration board
- Refer to the Owner's Manual for notes on the operation.
- Level
- On the calibration board
- For checking the horizontal position
- Left Angle Bracket
- Calibration Tool - Spacing Laser:VAS6350/2 mount
- Calibration Board
- Between the mounts on the calibration board and the Calibration Tool - Wheel Center Mountings:VAS6350/1 -dimension A- 1.47 m through 1.90 m