Windshield Wiper Arms, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Danger of causing damage to the windshield wiper axle.
- The windshield wiper axles can get damaged when removing the windshield wiper arms without using the Puller - Wiper Arm Kit - Puller 1:T10369/1 .
NOTE:
If the windshield wiper motor is to be run during the work procedure, the hood must be closed. Otherwise, the voltage supply of the wiper motor will be interrupted.
-- Bring the windshield wiper into service position. Refer to WIPER, MOVING INTO SERVICE POSITION .
-- Pry the caps -arrows- off of the windshield wiper arms -1- with a screwdriver.
-- Loosen the nuts -2- a few turns.
-- Position the :T10369/1 on the wiper arm -1- as illustrated.
-- Position the thrust piece -2- on the wiper axle.
-- Rotate the bolt -3- clockwise until the wiper arm is removed from the axle.
-- Remove the nuts and remove the wiper arm.