Wiper, Moving Into Service Position

WARNING: This page is about a different variant/trim than selected.

NOTE:

If the windshield wiper motor is to be run during the work procedure, the hood must be closed, otherwise the voltage supply of the wiper motor will be interrupted.

CAUTION:

Risk of damaging the hood by running the wipers back in basic position.

Do not drive a vehicle with windshield wiper arms folded up.
The windshield wipers automatically go back into their rest position when the wiper switch is activated or when driving faster than six km/h.

-- Make sure the wiper blades are not frozen.

-- Quickly turn on the ignition and then turn it off again.

-- Press the "One-tap wiping" within 10 seconds.

The windshield wipers run into "Service position".