Seal On Bevel Box Between Transmission And Bevel Box, Removing And Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Puller - Crankshaft/Power Steering Seal: T20143
Puller - Crankshaft/Power Steering Seal: T20143/1
Puller - Crankshaft/Power Steering Seal: T20143/2
Seal Installer - Bevel Box: T10298
Grease. Refer to the Parts Information.

Procedure

-- Remove the bevel gear. Refer to BEVEL BOX, REMOVING .

-- Pry out the sealing ring on bevel box using the : T20143/1 or : T20143/2 .

Fig 1: Identifying Pulling Hook T20143/1 Or T20143/2 To Pry Out Sealing Ring On Bevel Box

Courtesy of AUDI OF AMERICA, LLC

-- Coat outer circumference and sealing lips of new seal with transmission fluid.

Fig 2: Identifying Oil Seal

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing- and dust lip -arrow- half way with sealing grease; sealing grease. Refer to the Parts Information.

-- Install the seal all the way in using the : T10298 . Be careful not to tilt it.

Fig 3: Driving In Sealing Ring As Far As Stop Using Thrust Piece T10298

Courtesy of AUDI OF AMERICA, LLC

-- Install the bevel box. Refer to BEVEL BOX, REMOVING .