Bevel Box, Tightening Specification
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Tightening Specification on the Bevel Box on the Transmission.
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -Arrows- | Install the bolts all the way in by hand |
| 2. | -Arrows- | 40 Nm |
| 3. | -Arrows- | Tighten 90° further |
Tightening Specification and Sequence for Bevel Box Bracket, Vehicles with TFSI Engine
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1- | Install the bolts all the way in by hand |
| 2. | -2- | 40 Nm |
| 3. | -1- | 40 Nm |
Tightening Specification and Sequence for Bevel Box Bracket, Vehicles with TDI Engine
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1- | Install the bolts all the way in by hand |
| 2. | -2- | 40 Nm |
| 3. | -1- | 40 Nm |
Additional Tightening Specifications
- Bevel box assembly overview. Refer to OVERVIEW - BEVEL BOX .
- Differential assembly overview. Refer to OVERVIEW - DIFFERENTIAL .
- Subframe mount; subframe mount assembly overview. Refer to OVERVIEW - SUBFRAME MOUNT 2.0L or OVERVIEW - ASSEMBLY MOUNTS 2.0L DIESEL .
- EGR; assembly overview - EGR. Refer to OVERVIEW - EXHAUST TEMPERATURE REGULATION .
- Driveshaft; assembly overview - driveshaft. Refer to OVERVIEW - DRIVE AXLE .
- Lower control arm, control arm assembly overview; lower control arm, control arm. Refer to OVERVIEW - LOWER CONTROL ARM AND BALL JOINT .
- Noise insulation; assembly overview - noise insulation. Refer to OVERVIEW - NOISE INSULATION .