Drive Plate With Anti-Friction Bearing, Removing And Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the drive plate from the compressor shaft. Refer to A/C COMPRESSOR DRIVE PLATE, REMOVING AND INSTALLING .

-- Remove the circlip -A-.

Fig 1: Identifying Securing Ring, Drive Plate & Bevelled Side

Courtesy of AUDI OF AMERICA, LLC

-- Remove the drive plate -B-.

NOTE:

Replace circlip -A-.

Clean the A/C compressor flange before sliding on drive plate.

When installing circlip -A-, note that it cannot be bent open more than is necessary for installation.

Insert circlip -A- on correct side, the side with beveled insertion edge -C- faces away from A/C compressor (install flat side facing compressor).