LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S6 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 631 (Heating, Ventilation & Air Conditioning (1 Of 2) (As Of 06.2014)) >> 87 Air Conditioning >> A/C Compressor >> A/C Compressor Drive Plate, Removing And Installing

A/C Compressor Drive Plate, Removing And Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the drive plate with overload protection. Refer to DRIVE PLATE WITH OVERLOAD PROTECTION, REMOVING AND INSTALLING .

Remove the drive plate

-- Disconnect the drive plate -C- by turning using a conventional band wrench (with webbed band) in direction of -arrow D-, counterhold compressor shaft -A- using a retainer -B- on compressor shaft -A-.

Fig 1: Loosening Drive Plate & Providing Support For Compressor Shaft By Applying Counterhold To Compressor Shaft
GWWA87-0625Courtesy of AUDI OF AMERICA, LLC
NOTE:

Depending on the version of the A/C compressor (the A/C compressor shafts are different), use a wrench or, for example, a Extension with Counter Holder 2 T10001/10 from the Shock Absorber Set T10001 or Counterhold - Shock Absorber3079 to counterhold.

Connect the drive plate

-- Lightly coat the rubber elements -B- with soapy water (as a lubricant) to install.

Fig 2: Identifying Rubber Elements & Drive Plates
GWWA87-0626Courtesy of AUDI OF AMERICA, LLC

-- Insert rubber element -B- in the drive plate -A- according to illustration.

-- Insert drive plate -A- with rubber elements -B- onto drive plate -C- according to illustration until it makes contact with A/C compressor shaft.

NOTE:

This illustration shows the rubber element -B- in version "1". Rubber elements -B- of version "2" are joined to each other at top.

-- Bolt the drive plate -C- onto compressor shaft -A- by rotating in direction of -arrow E-.

Fig 3: Loosening Drive Plate & Providing Support For Compressor Shaft By Applying Counterhold To Compressor Shaft
GWWA87-0625Courtesy of AUDI OF AMERICA, LLC

-- Tighten the drive plate -C- to 30 Nm by turning it in the direction of -arrow E- using a conventional strap wrench (with cloth tape); hold the compressor shaft -A- using a counter holder -B- on the compressor shaft -A-.

NOTE:

Depending on the version of the A/C compressor (the A/C compressor shafts are different), use a wrench or, for example, a Extension with Counter Holder 2 T10001/10 from the Shock Absorber Set T10001 or Counterhold - Shock Absorber3079 to counterhold.

scientia non olet · About LEMON Manuals