Drive Plate With Overload Protection, Removing And Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the A/C compressor. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING (A/C Compressor, Removing and Installing, Vehicles with 8-Cylinder FSI Engine).

Remove the drive plate

-- Remove bolts -A-.

Fig 1: Identifying Bolts, Overload Protection -B-, And Drive Plate -C-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Use a commercially available band wrench (with webbed band) to counterhold at drive plate -C-.

Installing drive plate

-- Position drive plate with overload protection -B- onto drive plate -C-.

-- Install the bolts -A- and tighten by hand.

-- Check the drive plate run-out -B-. Refer to DRIVE PLATE WITH OVERLOAD PROTECTION, CHECKING RUN-OUT AND ADJUSTING .

-- Tighten the bolts -A- (tightening specification: 10 Nm).

-- Check the drive plate run-out -B- once more. Refer to DRIVE PLATE WITH OVERLOAD PROTECTION, CHECKING RUN-OUT AND ADJUSTING .