Left Flange Shaft Seal With Transmission Removed: Removing
- Transmission removed, refer to Removal and Installation .
Place VAS 6208 underneath transmission.
-- Remove the bolt -arrow- and drain the transmission oil.
-- Install and tighten the bolt -arrow-. Tightening specification -20- TRANSMISSION HOUSING .
-- Remove bolts -arrows- on left flange shaft mounting bracket.
-- Remove the flange shaft from the transmission in direction of -arrow A-.
If it is not possible to remove the left flange shaft by hand, use the slide hammer-complete set VW 771 to remove it.
Attach the plate from the T10037 to the flange shaft -arrows- and attach the spindle from the VW 771 (nuts -A-).
-- Remove the right flange shaft by installing the T10037 to the final drive cover -arrow-.
-- Remove bolts -arrows-.
Danger of damaging the differential.
- Slowly and carefully remove front final driver cover from transmission housing. Otherwise differential can fall out of transmission.
- A damaged differential may not be installed again. If the differential gets damaged, then the transmission must be replaced.
-- Carefully remove the front final drive cover; when doing this some transmission oil will drain out.
-- Carefully remove the differential -arrow- and lay it on a soft support.
-- Pry out the left flange shaft seal.
-- Thoroughly clean the area where the transmission is accessed.