Overview - Windshield Washer System: Notes

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Washer Fluid Reservoir, Hoses And Nozzles

Courtesy of AUDI OF AMERICA, LLC

Screw
- Tightening Sequence. Refer To Figure
O-Ring
- Replace if damaged.
Grommet
- Replace if damaged.
Filler Tube
- For the washer fluid reservoir
- Removing and installing. Refer To WASHER FLUID RESERVOIR FILLER TUBE, REMOVING AND INSTALLING .
Support Ring
Nut
- Threaded Connection Shared With Tower Brace
- Tightening Specification. Refer To MOUNTING BRACKET, SHOCK ABSORBER FORK, UPPER CONTROL ARM AND TOWER BRACE OVERVIEW
Cap
- For the filler neck
Washer Fluid Hose
- For the windshield washer system
Right Spray Nozzle
- Depending on vehicle equipment with Right Washer Nozzle Heater -Z21-
- Removing and installing. Refer To SPRAY NOZZLES, REMOVING AND INSTALLING .
- Adjusting. Refer To SPRAY NOZZLES, ADJUSTING
Left Spray Nozzle
- Depending on vehicle equipment with Left Washer Nozzle Heater -Z20-
- Removing and installing. Refer To SPRAY NOZZLES, REMOVING AND INSTALLING .
- Adjusting. Refer To SPRAY NOZZLES, ADJUSTING
Washer Fluid Reservoir
- Removing and installing. Refer To WASHER FLUID RESERVOIR, REMOVING AND INSTALLING .
Headlamp Washer Pump -V11-
Grommet
Washer Fluid Hose
- For the headlamp washer system
Retaining Ring
- For Windshield Washer Pump -V5-
Windshield Washer Pump -V5-
- Removing and installing. Refer To WINDSHIELD WASHER PUMP, REMOVING AND INSTALLING .
Grommet
Screw
- Tightening Sequence. Refer To Figure
Grommet
Windshield Washer Fluid Level Sensor -G33-
- Removing and installing. Refer To WINDSHIELD WASHER FLUID LEVEL SENSOR, REMOVING AND INSTALLING .