Accelerator Pedal Position Sensors -G79- / -G185-, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
- Tightening specification. Refer to OVERVIEW - ACCELERATOR PEDAL MECHANISM .
-- Engage the accelerator pedal module -4- on the bottom of the pedal bracket -1-, insert the centering pin -2- and tighten the bolt -3-.
-- Install the lower instrument panel cover on the driver side. Refer to STORAGE COMPARTMENTS AND COVERS .
NOTE:
Depending on the engine/transmission version, adaptation in the "Guided Functions" operating mode is necessary after replacing it.
Perform the adaptation, if a menu item is available in the "Guided Function". Refer to Vehicle Diagnostic Tester.