LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 50 (Maintenance, Diagnosis (Maintenance Procedures) (Coupe)) >> 03 Maintenance, Diagnosis >> Maintenance Procedures >> Spark Plugs, Replacing >> 6-Cylinder 3.0L TFSI Gasoline Engine >> Installing

6-Cylinder 3.0L TFSI Gasoline Engine: Installing

WARNING: This page is about a different variant/trim than selected.

-- Install the new spark plugs using spark plug wrench:VAS 3122B  and tighten them to the tightening specification.

-- Lubricate the ignition coils. Refer to IGNITION COIL, LUBRICATING .

-- Align all the ignition coils one after the other and insert them loosely into the spark plug shaft.

-- Press the ignition coils evenly onto the spark plugs by hand. Do not hit them.

-- Connect the connector to the ignition coil until it clicks into place.

-- Tighten the screws to the tightening specification.

-- Installation Is The Reverse Of Removal.

-- Install engine cover. Refer to ENGINE COVER, REMOVING .

Tightening Specifications Nm
Spark plugs in cylinder head 30
Connector strip screws 5
scientia non olet · About LEMON Manuals