Diagnostic Data, Recording
WARNING: This page is about a different variant/trim than selected.
NOTE:
In Order To Record All The Diagnostic Data, It Is Necessary To Start And Complete The Guided Fault Finding Correctly.
Do not disconnect the connection to the vehicle before the procedure is complete.
-- Connect VAS 50XX/61XX. Refer to VEHICLE TESTER, CONNECTING .
-- Perform The Following On The Diagnostic Tester:
- Guided Fault Finding
- Vehicle identification
- Perform a vehicle system test.
-- Continue To Follow The Procedure On The Tester.
Before Going On To Fault Finding:
- GO TO
- FINISH
-- Send the diagnostic log online.
-- Continue to follow the procedure on the tester until the confirmation that the online log has been sent.
NOTE:
It Is Necessary To Have A Working Network Connection In Order To Send The Log Online.
Any DTC memory entries are erased.