Steering, Checking For Leaks

WARNING: This page is about a different variant/trim than selected.

NOTE:

Following installation operations and with no hydraulic fluid in the expansion tank, the steering system must be checked for leaks.

-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Start the engine.

-- Turn steering wheel in both directions to full lock and hold briefly.

This builds up the maximum possible pressure.

NOTE:

To avoid damage to pump, steering wheel must not be held at stop longer than 10 seconds during this test.

In this position, the following components must be checked for leaks.

This test can only be performed with bellows slid back.

-- Open spring-type hose clamp and boot hose clamp.

-- Push the boots back.

If fluid is visible in steering gear housing and/or in bellows, steering gear must be replaced.