Overview - Power Steering Pump, 6-Cylinder FSI, Without Dynamic Steering

Power Steering Pump, Removing and Installing, 6-Cylinder FSI Engine, Vehicles without Dynamic Steering. Refer to POWER STEERING PUMP, REMOVING AND INSTALLING, 6-CYLINDER FSI, WITHOUT DYNAMIC STEERING .

Power Steering Pump Assembly Overview 

Fig 1: Exploded View Of Power Steering Pump, Vehicles Without Dynamic Steering (6-Cylinder FSI)

Courtesy of AUDI OF AMERICA, LLC

1. Bracket
2. Sleeve
   • Drive the sleeve back slightly to install the power steering pump.
3. Bolt
   • 20 Nm 
4. Bolt
   • 20 Nm 
   • For securing the bracket to the engine.
   • Note the different bolt lengths.
5. Bolt
   • 20 Nm 
   • For securing the bracket to the engine.
   • Note the different bolt lengths.
6. Clamp
   • Always replace if removed
   • Tension using Hose Clip Pliers:VAG1275A 
7. Intake Hose
   • The "P" marking on the evacuation hose -arrow- must align with the formed seam -arrow- on the power steering pump.
8. Seal
   • Always replace if removed
9. Pressure Line
   CAUTION:

   • Insert The Pressure Line Completely When Installing.
   • Depending on the version, also mounted to the A/C compressor
10. Bolt
    • 9 Nm 
11. Power Steering Pump
    • Allocation. Refer to the Parts Information..
    • Fill with Hydraulic Fluid before installing
    • Delivery pressure, checking. Refer to POWER STEERING PUMP DELIVERY PRESSURE, CHECKING, 6-CYLINDER FSI .
    • Removing and installing. Refer to POWER STEERING PUMP, REMOVING AND INSTALLING, 6-CYLINDER FSI, WITHOUT DYNAMIC STEERING .
    • Bleed the steering. Refer to STEERING, BLEEDING AFTER REPLACING .
    • Check hydraulic fluid level. Refer to POWER STEERING FLUID LEVEL, CHECKING .
    • Steering System, checking for leaks. Refer to STEERING, CHECKING FOR LEAKS .
12. Belt Pulley
13. Bolt
    • 22 Nm 
14. Bolt
    • 20 Nm 
    • For Securing The Power Steering Pump To The Bracket
15. Bolt
    • 20 Nm 
    • For Securing The Bracket To The Engine.