Overview - Hydraulic Power Steering, 8-Cylinder FSI: Notes

Line And Hose Securing Elements, Assembly Overview

1. Reservoir bracket to body. Refer to Fig 2
2. Reservoir in bracket. Refer to Fig 3
3. Bolt in bracket. Refer to Fig 2
4. Return hose bracket to the longitudinal member. Refer to Fig 4
5. Hydraulic oil cooler to condenser. Refer to Fig 5
6. Power steering pump to engine/transmission. Refer to OVERVIEW - POWER STEERING PUMP, 8-CYLINDER FSI, WITH DYNAMIC STEERING  or OVERVIEW - POWER STEERING PUMP, 8-CYLINDER FSI, WITHOUT DYNAMIC STEERING .
7. Pressurized line to crossbrace. Refer to Figure
8. Pressure line connection installation location. Refer to Figure
9. Return line to the subframe. Refer to Figure
10. Return line bracket to subframe. Refer to Figure
11. Return line bracket to the longitudinal member. Refer to Fig 4

Reservoir Bracket To The Body 

-- Secure the bracket -2- to the body with bolts -1-.

-- Secure the reservoir -4- in the bracket -2- using the bolt -3-.

Reservoir In The Bracket 

-- Insert the reservoir with the tab -1- in the opening in the bracket -2-.

Line Bracket For Lines To The Longitudinal Member 

-- Secure the return line -1- to the left longitudinal member using the line bracket -3-. Insert the return line -1- with the marking -arrow A- in the line bracket -3-.

-- Insert the intake hose -4- in the line bracket -6-. Clip the line bracket -6- into the bracket -5-.

-- Secure the return line -2- with the nuts -7- and the bracket -5- on the left longitudinal member.

1. Return line from the hydraulic fluid cooler to the reservoir
2. Return line from the power steering gear to the hydraulic oil cooler

-Arrow- points in direction of travel.

Installation location on the return line connection -2-. Refer to HOSE LINES TO RESERVOIR, HYDRAULIC FLUID COOLER AND RETURN LINE INSTALLED POSITION .

Return line -1- and intake hose -4- installation location on the reservoir. Refer to HOSE LINES TO RESERVOIR, HYDRAULIC FLUID COOLER AND RETURN LINE INSTALLED POSITION .

Hydraulic Fluid Cooler To Condenser - S 5 

-- Position the hydraulic oil cooler -1- on the brackets -2- and then engage it into the brackets -3-.

Lines to the hydraulic oil cooler. Refer to HOSE LINES TO RESERVOIR, HYDRAULIC FLUID COOLER AND RETURN LINE INSTALLED POSITION .