BELT PULLEY, REMOVING AND INSTALLING, "Denso" A/C COMPRESSOR, VERSION "1": Notes

WARNING: This page is about a different variant/trim than selected.

A/C COMPRESSOR WITHOUT A/C CLUTCH -N25-

NOTE:

Observe Notes On Replacing Belt Pulley -E-. Refer to OVERVIEW - BELT PULLEY, "Denso" A/C COMPRESSOR, VERSION "1" .

Fig 1: Identifying Belt Pulley Components, Denso Version 3

Courtesy of AUDI OF AMERICA, LLC

Perform Preparatory Work As For Removing Belt Pulley. Refer to PRELIMINARY WORK FOR REPLACING BELT PULLEY .

The belt pulley is made of plastic and is sensitive to impact, therefore take special care when handling it.

If the drive plate -C- overload protection activates, rotate the pulley -E- using the outer part of the drive plate -C- so that the compressor shaft -B- and the hexagon head on the drive plate -D- (inner part of the drive plate -C-) do not rotate.