Inner Tail Lamp, Removing And Installing, AUDI A5, Led Through My 2012: Installing

WARNING: This page is about a different variant/trim than selected.

Install In Reverse Order Of Removal.Note The Following:

NOTE:

Make Sure The Seal Between The Body And Tail Lamp Housing Seals Correctly.

-- Position The Inner Tail Lamp On The Outer Edge Of The Rear Lid.

-- Slide The Clamping Bracket -3- Onto The Inner Tail Lamp Threaded Pins And Install The Nut -4- Loosely.

Fig 1: Sliding Clamping Bracket -3- Onto Inner Tail Lamp Threaded Pins & Install Nut -4- Loosely

Courtesy of AUDI OF AMERICA, LLC

-- Slide The Large Clamping Bracket -1- Onto The Threaded Pins On The Inner Tail Lamp And Tighten The Nuts -2- And -4-.

NOTE:

When Tightening The Nuts, The Clamping Bracket Wedges Itself Onto The Rear Lid -arrows-.