LEFT/RIGHT BACK-UP LAMP BULB -M16- / -M17-, REMOVING AND INSTALLING, AUDI A5, LED Through MY 2012: Installing
WARNING: This page is about a different variant/trim than selected.
- Tightening Specification. Refer to OVERVIEW - REAR LID TAIL LAMPS, LED, .
Install In Reverse Order Of Removal.Note The Following:
-- Insert the new bulb in the socket without touching the bulb glass with bare hands.
-- Slide the large clamping bracket -1- onto the threaded pins on the inner tail lamp and tighten the nut -2-.
NOTE:
When Tightening The Nut, The Clamping Bracket Wedges Itself Onto The Rear Lid.